Aluminium plate made of DIN EN AW-5083 Al Mg4.5 Mn0.7 cast, EN 573-3
The panels are finely milled, sharp-edged and film coated on both sides.
Thickness tolerance: -0.1 to 0.18mm
Length tolerances: +/- 0,4mm
Width tolerance (supplier): +/- 0,5mm
In this state, it is low in stress and particularly suitable where extreme machining is required and medium strength is sufficient.
Excellent machinability, i.e. good drilling, turning and milling properties and very good weldability.
alloy is resistant to seawater and corrosion.
Translated with www.DeepL.com/Translator